Norseman 447 CC Cutter

Accommodations

The interior cabinetry is flawless grain Burmese teak with laminated curved doorways and cabinet trim. Drawers have dovetail corners adding strength to the joints. The entire cabin sole is teak & holly.  

Aft of the chain locker in the forepeak is a V-berth with shelves port and starboard, an opening hatch, 12 volt fan, a hanging locker to starboard. Forward head area follows to port, mirrored cabinet and an opening port.

Salon is next with a U-shaped settee & dinette to port.  The aft curved section of this settee has been squared off to allow for greater comfort and there is a mirrored main bulkhead offering a feeling of greater space. Opposite to starboard is a single settee which converts to over under berths. There are shelves and lockers outboard of both settees and a fireplace heat stove with glass window and tile heat protection.

Navigation area follows to starboard. U shaped galley is to port of the companionway. Aft of the Nav area is a wet locker in the passageway to the owner’s aft cabin. Outboard on the passageway is a sound insulated compartment where previously a generator was installed (removed). Inboard on the passageway is the main engine accessible through two large hinged doors. Aft berth is full beam King.  There is a hanging locker to starboard, cabinets & shelves port and starboard, an opening, opening port lights port & starboard & two fixed ports on transom. There is a mirrored bulkhead and an adjoining head to port with separate stall shower and marine toilet. From the salon on center is the companionway with five steps leading up to the oval center cockpit.  

Galley

• Shipmate stainless 3-burner LPG stove & oven 2 LP tanks in aft locker
• Crosby Engine Driven/120V  cold plate top & front loading refrigerator w/5" insulation
• Crosby Engine Driven/120V  cold plate top loading freezer w/5" insulation 
• Refrigeration system needs service for a refrigerant leak.
• Large custom one piece Double stainless sink and counter top (2019) 
• Faucet w/pressure hot & cold water 
• Foot pumps for galley sink fresh water and salt water
• 120 gallons fresh water tank (180 gallon tankage converted to fuel)
• 6 gallon water heater
• Water heater
• Abundant counter and storage area

Electrical System

• Shore power inlet and cord
• Breaker panels 120V and 12V
• A 150-amp alternator was installed on the engine with 140-amp alternator spare
• All AC appliances can be run with inverter when away from shore power.
• Dock power isolator/transformer to protect against poorly grounded shore electric supply.
• Bonding system to protect against stray current.
• Diesen engine driven alternator with 150'amp output
• Trace U2512 inverter/battery charger with 2500-watt capacity
• Battery parallel switch
• (4)  6V house and (2) 180 amp engine start batteries, sealed gel
• Ample Power isolator eliminator for engine battery
• Newt Step regulator for solar panels- solar panels not available at this time
• Dock power isolator/transformer
• Ample Power Emon II battery monitor and 12/110V voltage meter
•  

Deck Equipment

• Deck and anchor wash down systems
• 66# Bruce anchor with 200' 3/8" chain and 200' 3/4" nylon rode
• 44# Bruce anchor on custom stern pulpit mount
• Twin bow anchor rollers and stern anchor roller
• 25# Danforth kedge anchor with 50' 3/8" chain and 200' nylon rode
• 2 outboard mounts on stern pulpit,
• SCUBA tank racks,
• Novalift outboard davit 
• Custom S/S boarding ladder at port gate
• Lifesting, 3 life jackets and MOB pole
• S/S arch, boom gallows, bimini, cockpit awning and Sunbrella weather cloths with line pockets Firdell Blipper radar reflector
• Nilsson electric windlass
• Mast pulpit to starboard
• Hard dodger with grab rails 
• search light, spreader lights and navigation lights
• Monitor wind vane
• 5 deck prisms
• Modified fin keel with skeg-hung rudder
• Solid fiberglass hull
• "Treadmaster" non-skid decks
• Flares and fire extinguishers 

Engine and Mechanical

• Dual Racer Fuel filtering systems with electric prime pump
• Fresh water cooling system
• 3-blade propeller on boat plus spare propellers (2-blade prop and Martec 3-blade 3-blade prop)
• Raw water sea strainer
• Wheel steering and emergency tiller
• 2 manual marine heads with macerator and holding tank
• Borg-Warner V-drive transmission overhauled 6/00
• 25-gal/hour Sea Recovery watermaker (requires servicing)
• Engine room blower system Oil pressure and engine temperature alarms
• Stove and engine fuel shut-off valves
• Water, fuel and holding tank gauges replaced with Wema gauges ?98 1 automatic and 2 manual bilge pumps
• 3 water tanks (S/S) and 4 fuel tanks (2 iron and 2 S/S)
• Engine room fire extinguisher system
• Speed seal cover on impeller housing
• spares for all engine molded hoses and belts

Sails and Rigging

• Fully battened main sail w/lazy jack

  Dutchman boom brake and boom vang

  3 Sobstad dacron sails (main, 140% genoa and staysail)

  S/S wire standing rigging

  Harken roller furling genoa and staysail

  9 Lewmar winches

  Navtec hydraulic backstay adjuster on insulated backstay

  Aluminum keel-stepped spar with mast steps

  Forespar whisker pole on mast track

  Running backstays

Disclaimer

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. Buyer should assume that items on the vessel at the time of viewing, but not specifically listed on this specification sheet, are not included with the sale of the yacht, and should instruct his agents, or his surveyors to investigate such details as the buyer desires validated. Buyer assumes responsibility to verify all speeds, consumptions, capacities and other measurements contained herein and otherwise provided, and agrees to instruct his surveyor to confirm such details prior to purchase. This vessel is subject to sale, price and inventory changes, and withdrawal from market without notice.